FREE SHIPPING ON ORDERS OVER $25
The Elrick Brander has been designed to give many operating advantages and longer working life. The special heating system allows the tool to heat very quickly and maintain a higher operating temperature, but still ensure a longer working life of the brander. The balance and minimal weight of this brander make it easier to handle and control. This is especially important during long hours of use.
The Elrick Brander is constructed to hold up under everyday use, and will give the user long efficient service. Branders operate at high temperatures and should be used very carefully. Severe burns or fire may result if the tool is used improperly. Keep Branders away from combustible materials. Do not place heated branders in areas where others may accidentally come in contact with them. Always use the correct voltage the tool was designed for. Plugging a 120 volt tool into a 240 volt circuit is extremely dangerous and will cause the brander to fail. Avoid leaving the tool plugged in for long periods of time without use because it is possible to build up and excess of heat. When in use, never rest the brander in a position with the branding head down. Always use the attached stand to rest the brander on a non-combustible surface. Do not strike brander against hard surfaces to shake off dirt and sand. Clean branding head with a brass brush.
The electrical cord used in the Brander is made of a special flexible, heavy-duty industrial grade cable designed to give you many years of service. However, excessive flexing or twisting may damage the cable. When branding, never place your hand or body against the cord and strain relief. Check regularly to make sure the cord is not twisted due to tool rotation and correct if necessary. DAMAGED CORDS ARE NOT COVERED UNDER WARRANTY!
Compliance and Restrictions