Rubberhog RH-129 | 4" 3/4" I.D., Coarse 390, Contour Wheel

Rubberhog RH-129 | 4"  3/4" I.D., Coarse 390, Contour Wheel

RETREADING SIDEWALL WHEELS

For “Bead to Bead” buffing on Marangoni, Collman, and other sidewall buffers.

• Designed for shoulder and sidewall preparation.
• Used on manual or automatic sidewall buffers.
• Fast and effective removal of oxidized rubber.
• Provides a uniform texture maximizing rubber-to-rubber bond.
• Used with or without traditional wire brushes.
• Excellent durability, reducing your cost per buff.

GOOD / BAD WHEEL REPLACEMENT GUIDE
Rubberhog SSG® technology generates exceptional wheel life. However, a worn-out buffing wheel of any kind may cause risk of repair failure! Worn wheels can scorch the rubber, preventing the repair from bonding properly. Rubberhog wheels in good condition produce the safest and highest-quality repairs. You are strongly encouraged to replace when wear is visible.

GOOD

• New wheels have visible, very sharp teeth
• You can feel the ‘bite’ when rubbing with your fingers
• Very little heat is created while buffing
• Removes material quickly and easily

BAD

• Displays teeth that are rounded/broken and shiny
• Little aggressiveness; much less ‘bite’ to the touch
• May have heavy rubber build-up within the teeth
• Produces lots of heat and smoke

CLEANING RECOMMENDATIONS
It is important to first properly clean the tire liner to remove contaminants prior to buffing. However, if the wheel does plug up, you may soak it in brake cleaner or a similar solvent, then clear with a hand wire brush. If you find the wheel still plugs after using on clean rubber, or if it shows obvious signs of wear, it should be replaced.

Compliance and Restrictions:

⚠️WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov